Flash Operation With The Synch Cable; Flash Operation With A Radio Module; Warning Tone If Studio Flash Unit Overheats - Metz mecastudio TL-300 Bedienungsanleitung

7.3 Flash operation with the synch cable

The studio flash unit can be operated with
the included synch cable. To do this, connect
the synchronous socket of the camera to the
socket of the studio flash unit.
If the camera does not have a synch socket,
then you need a flash mount adapter from
the Metz accessories. Slide the flash mount
adapter into the flash mount of the camera
and connect it to the socket
flash unit using the supplied synchronisation
cable.
+
Switch off the studio flash and the camera
before plug in the synch cable.

7.4 Flash operation with a radio module

The studio flash unit can be triggered using
a radio module. To do this, attach the
transmitter module to the camera and the
receiver module to the studio flash unit.
Connect the receiver module and the studio
flash unit with a synch cable.
ERROR
Overheating
on the studio
8 Warning tone if studio flash
unit overheats
The studio flash unit increases the amount of
time following a flash if there is a risk of over-
heating.
If you hear a continuous tone and "ERROR
Overheating" appears in the display, then
you should reduce the flash intensity and
flash frequency.
If the continuous tone persists and the dis-
play remains, then the studio flash unit must
be cooled for at least 30 minutes.
During this time
- you must switch off the modelling
lamp.
- you must not trigger any flashes.
k
89