Setting The Studio Flash Unit; Setting The Flash Output - Metz mecastudio TL-300 Bedienungsanleitung

+
The automatic soft start protects the flash
tube of the studio flash unit. Therefore, the
set flash output will be reached after appro-
ximately 1-2 seconds.
- Switching off the studio flash unit:
Press power switch
position (OFF)
- All displays go off
- If the modelling lamp was switched on,
it goes off.
so that it is in

6 Setting the studio flash unit

6.1 Setting the flash output

The brightness of the flash is determined by
the output of the flash tube. The output can
be set on the studio flash unit from 1.0 to 6.0
in intervals of 0.1:
Teillichtleistung
1
1/2
Servo
1/4
3.0
1/8
1/16
OFF
1/32
• Press power switch
Flash Power
on (ON).
4.0
• Press the touchscreen.
• Press the sensor button
desired flash intensity is displayed on
touchscreen
to reduce flash intensity. The studio
flash unit loses flash readiness, adjusts the
power of the flash capacitor in line with the
Flash Power
new, lower value, and then displays flash
4.0
readiness again.
• Once the capacitor of the studio flash unit
has enough power for the displayed flash
intensity, button
Anzeige im
Touchdisplay
6,0
5,0
4,0
3,0
2,0
1,0
so that it is in positi-
, until the
. Press the sensor button
will light up.
83
k