Delivery Contents; Unpacking The Studio Flash Unit; Checking The Delivery Contents - Metz mecastudio TL-300 Bedienungsanleitung

• Only maintain and clean the studio flash
• Rapid changes in temperature may lead to
• Only use original Metz spare parts for the
Maintenance work on the studio flash unit
must be carried out only with tools insulated
in accordance with IEC 60900.
k
78
unit as described in chapter 11 of these
operating instructions.
condensation. Allow time for the unit to
become acclimatised!
studio flash unit that comply with the
stipulated specification. See chapter 14.

2 Delivery contents

2.1 Unpacking the studio flash unit

Take the studio flash unit out of the
packaging carefully.
+
Keep all parts of the packaging for subse-
quent transport and/or storage of the studio
flash unit.

2.2 Checking the delivery contents

Please also refer to the fold-out picture page
at the end of the guide.
1 TL-300 / TL-600 studio flash unit with
modelling lamp and flash tube
1 Protective cap
1 Reflector SR-18 (not in kit)
1 Synchronisation cable 4.5V (4m)
1 Power cord (4m)
1 Operating instructions in 6 languages.
Check whether all parts of the delivery
contents are there and are not damaged.
If the delivery contents are incomplete
and/or damaged, please contact your dealer.