Unit Components And Functions Of Studio Flash Unittl-300/Tl-600 - Metz mecastudio TL-300 Bedienungsanleitung

3 Unit components and functions
of studio flash unit
TL-300/TL-600
This chapter gives you an overview of the
parts of the studio flash unit and briefly
explains their main function.
+
Please also refer to the fold-out picture page
at the end of the guide.
The reflector bundles the flash light in the
flash area that is to be illuminated
Release lever for releasing the attached
reflector or the attached protective hood
Air slits facilitate air circulation to cool the
studio flash unit
Photocell for automatic triggering of a
flash
Socket for mains connection for
connecting the power cord
Power switch for switching the studio
flash unit on and off
Spare fuse
3,5mm socket for the
synchronisation cable or radio receiver
Mini USB port for software updates
For more information, visit the Metz home-
page at www.metz.de.
Touchscreen
shows the value of the set flash output or
modelling lamp
Sensor button for configuring the
modelling light
Button
- for triggering a test flash
- for indicating flash readiness
Sensor button for configuring the beep
that confirms the flash is ready
Sensor button for configuring the
touchscreen
D
Button for opening the menu
Sensor button for configuring
synchronisation
Clamping screw to hold the lamp shade
Holder for lamp shad
Clamping screw for the tilt of the studio
flash unit
Tripod holder with clamping screw
k
79