Removing/Replacing The Protective Cap; Plugging In/Unplugging The Bulb Of The Modelling Light; Putting On/Taking Off Reflector - Metz mecastudio TL-300 Bedienungsanleitung

5.1.1 Removing/replacing the protective cap

- Removing the protective cap
- Push release lever
held there.
- Twist the protective cap in a counter-
clockwise direction as far as it will go
and then lift it off the studio flash unit.
- Let go of release lever
- Put on the protective cap
- Push release lever
held there.
- Plug protective cap into the three
plug-in openings on the unit. In the
process, opening for the lamp screen
must point down.
- Let go of release lever
- Twist reflector
direc-tion until you feel it snap into
place.
5.1.2 Plugging in/unplugging the bulb of the
modelling light
+
The bulb of the modelling lamp in
the delivery contents is suitable for mains
voltages between 90V to 250V.
The studio flash unit must be switched
off and the power plug must be pulled
out of the power socket.
Bl on use a clean, grease-free cloth or
cotton gloves to take hold of bulb a!
back and keep it
.
back and keep it
.
in a clockwise
- Plug in bulb a
- Screw lamp a carefully into the socket.
- Pull out bulb a
- Unscrew lamp a carefully from the
socket.
- If no further flash photographs will
be taken, then put the protective cap
back on.

5.1.3 Putting on/taking off reflector

- Putting on the reflector
- Push release lever back and keep it
held there.
- Plug reflector into the three plug-in
openings on the unit. In the process,
opening for the lamp screen must point
down.
- Let go of release lever
- Twist reflector in a clockwise
direc-tion until you feel it snap into
place.
- Removing the reflector
- Push release lever back and keep it
held there.
- Twist reflector in a counter-clockwise
direction as far as it will go and then lift
it off the studio flash unit.
- Let go of release lever
- If no further flash photographs are to
be taken, then put the protective cap
back on.
k
.
.
81