Assembly/Operation - Metz Studio Trigger ST-1 Kurzanleitung

Description
1 LEDs for the groups
(A, B, C, D)
2 Buttons for the group selection
3 Manual release button
4 Increasing the performance
- Tap: Light performance is increased in 0.1 steps
- Keep pressed down: Switching to modelling light by tapping
the performance of the modelling light is increased
5 Reducing the performance
- Tap: Light performance is reduced in 0.1 steps
- Keep pressed down: Switching to modelling light by tapping
the performance of the modelling light is reduced
6 Base connector
7 DIP switch in the battery compartment for setting the channel
8 Battery compartment with lithium battery CR2032

Assembly/operation

1 . Switch off the camera and ST-1 before assembly or disassembly.
2 . Turn the knurled nut fully against the ST-1 .
The locking pin in the base connector is now fully inserted into the
trigger housing.
3 . Slide the Studio Trigger with the base connector to the stop in the
accessory shoe on the camera.
4 . Turn the knurled screw against the camera body until it clicks into
place and clamp the ST-1.
On camera bodies without a locking hole, the spring-mounted lock-
ing pin sinks into the housing of the Studio Trigger, as a result the
surface is not damaged.
For disassembly, proceed in the reverse order.
Observe the safety instructions before start-up! Switch off the Studio
Trigger before assembly or disassembly.
English
3 – 4