Touch Control User Instructions - Teka VT TC 2P.1 Anleitung

* Change the timer time by following the
steps described
"Modifying the programmed time" until
00
the timer reaches .
NOTE: it is possible to set the time for
a heating element that has a
level. In this case, the timer will work as
a chronometer counting backwards.
Touch control user instruc-
tions (model VI TC 30 2I)
CONTROL PANEL ELEMENTS (see fig. 5)
1
On/off sensor button.
2
Indicator light of the heating element.
Power, time and residual heat indica-
3
tors.
Power/time reduction sensor button
4
(less).
Power/time increase sensor button
5
(more).
"Stop" function sensor button.
6
Timer/chronometer selection sensor
7
button.
8 Indicator light of the activated locking
option.
Indicator light of the timed heating ele-
9
ment.
NOTE: * Only visible when device is in
operation.
Actions are carried out using the sensors
in the section marked on the control panel.
It is not necessary put pressure on the
glass; by simply touching the sensor button
with your finger you will activate the desired
0
power function.
Each action is confirmed with a beep.
TURNING ON THE APPLIANCE
1 Touch the on sensor button
least one second.
The touch control panel is activated and all of
the power level indicators (3) have a
cooking zone is hot, the corresponding indi-
cator will have an
The next action must be taken within 10
seconds; otherwise, the touch control
panel will automatically turn off.
When the touch control panel is activated,
it can be disconnected at any time by tou-
ching sensor button
been locked (safety lock function activa-
ted). Sensor button
to disconnect the touch control panel.
(1) for at
0
. If a
H 0
instead of a .
(1), ieven if it has
(1) is always able
fig. 5
69
GB