Teka VT TC 2P.1 Anleitung Seite 68

2 Press either of the sensor buttons asso-
ciated with the heating element with
which you want to use the timer. After
doing so, the light corresponding to the
chosen heating element (11) will turn on
and a blinking
level indicator. The time indicator of the
clock (8) will show a blinking 00.
GB
3 Choose a timer time for the chosen hea-
ting element. This can be done using the
sensor buttons
device. The increase or decrease will be
done minute by minute, which allows for
a time that can vary between 1 and 99
minutes.
The time will be set after 5 seconds since
the last pulsation on the sensor buttons of
the clock. Afterwards, the digits will stop
blinking. If you have not chosen a value or
if you touch a sensor button other than
those indicated
timer will turn off.
Once the chosen time has passed, the
heating element where the timer was used
will disconnect and the clock will emit a
series of beeps for 1 minute. To stop the
beeping, touch any of the sensor buttons.
Modifying the programmed time
Once the timer has been set for a heating
element, the timer time may be changed if
desired.
1 Touch the sensor button of the clock
or (14/15) and choose the heating
element whose timer time you want to
change by touching any of its sensor
buttons.
2The timer indicator will then show you in
a blinking manner the remaining time of
the timer. The power level indicator of
the heating element will show a blinking
68
will appear in its power
or (14/15) of the
and (14/15), the
. At that time, you can change the timer
time by using the sensor buttons
and (14/15) of the clock.
The time will be set after 5 seconds have
passed since the last pulsation on the sen-
sor buttons of the clock or by touching the
sensor button of any heating element
other than the heating element correspon-
ding to the timer. Afterwards, the digits will
stop blinking.
If, after 5 seconds have passed the mar-
00
ked time is still , the timer has not been
set for this heating element. The indicator
light will turn off and the
Setting the timer for a new heating ele-
ment
It is possible to set the timer for more than
one heating element at a time. To do so,
repeat the steps in the section "Setting the
timer for one heating element".
When the timer is being used for more
than one heating element, the time indica-
tor (8) will alternately show the remaining
time for each one of the heating elements.
The value shown by the indicator corres-
ponds to the heating element whose
power level indicator is showing a blinking
and there is a light turned on next to the
indicator of the timed heating element.
Quickly turning off timer
It is possible to cancel the timer for a hea-
ting element in various ways:
* Simultaneously press the sensor buttons
and (14/15) del reloj. of the clock.
By doing so, the timer of the chosen
heating element ( blinking) will turn off.
* Turn off the heating element. The corres-
ponding heating element will be cancelled.
will disappear.