Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. INSTALLATION
3.1 Installing the top lid
The top lid hinge spigots are inserted evenly into the plug holes in the stove frame (at back,
left and right) (Fig. 23 & 24).
3.2 Flue gas connector direction
The pipe connector is factory installed at the back of the stove.
If a flue gas connection is required on the side, left or right, the following steps should be
taken:
-
Remove the pipe connector at the back by undoing the three fixing bolts M4 (Fig. 25).
-
Close the smoke hole with the pair of cover plates supplied (Fig. 26).
-
The smoke hole cover on the side wall and the inside cover should be removed. The
inside cover can be removed by taking the hotplate off and holding the cover screw
out the bolt (Fig. 27)
-
cut out the aluminium insulation with a knife (Fig. 23).
-
Screw the previously removed pipe connector from the back of the stove on to the side
using the three bolt holes (Fig. 28)
-
If the flue gas connection is to go up, then proceed as follows:
-
remove the pipe connector and close the back smoke hole.
-
Take the smoke hole cover from the hotplate (the best way is to lift the plate) and
attach the pipe connector firmly using the three visible bolt holes (Fig. 29 & 30).
-
Keep the remaining covers in a safe place for possible use later.
3.3 Installation of the heat exchanger and the heat sink
The heat exchanger and the heat sink are not part of the standard scope of supply of the
central heating stove. If required it can be retrofitted. The following is required:
-
Insert the heat sink probe in the fully into the immersion shell (Fig. 31).
-
Clamp the protective tube firmly in the immersion shell (Fig. 32).
-
To install the heat exchanger only the blind flange on the back of the stove needs to
be removed and the heat exchanger connected in its place (Fig. 33).
The heat exchanger has to be firmly bolted to the heating pocket (Fig 34).
Screw thread bolts can strip if too much force is used.
3.4 Installing the stove bar
Two screws underneath the front on the stove frame are already installed for attaching the
stove bar (Fig. 35).
-
open fire door
-
unscrew screws
-
lay one end of the bar on the fire door
-
first screw the bar on at the other end
-
for easier access to the screws, the two front covers on the left and right of the fire
door can be removed.
-
there is a screw at the bottom of each of the covers which must be undone. (Fig. 36)
ATTENTION
47
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
