Advanced Operation; Advanced Operations; Using The Sleep Timer; Enjoying Multi-Channel Software - Yamaha RX-SL100RDS Bedienungsanleitung

ADVANCED OPERATIONS

Using the sleep timer

Use this feature to automatically set this unit in the
standby mode after a certain amount of time. The sleep
timer is useful when you are going to sleep while this unit
is playing or recording a source.
Setting the sleep timer
STANDBY/ON
HALL
1
MUSIC
5
q/DTS
9
TV
1
Select a source and start playback on the
source component.
2
Press SLEEP repeatedly on the
remote control to set the
amount of time.
Each time you press SLEEP, the front
panel display changes as shown
below. The SLEEP indicator flashes while switching
the amount of time for the sleep timer.
SLEEP 120min.
SLEEP OFF SLEEP 30min.
The "SLEEP" indicator lights up on the front panel
display after the sleep timer has been set.
Canceling the sleep timer
Press SLEEP repeatedly on the remote control until
"SLEEP OFF" appears on the front panel display.
After a few seconds, "SLEEP OFF" disappears, and the
"SLEEP" indicator goes off.
SLEEP
y
The sleep timer setting can also be canceled by pressing
STANDBY on the remote control (or STANDBY/ON on the front
panel) to set this unit to the standby mode.
32
ADVANCED OPERATIONS
SLEEP
2
JAZZ ROCK ENTERTAIN
2 3 4
TV THTR MOVIE 1 MOVIE 2
6 7 8
NIGHT EX/ES STEREO
0 +10 ENT
EFFECT
AV
SLEEP
SLEEP 90min.
SLEEP 60min.
Lights
VCR VIDEO 1 VIDEO 2 DTV/CBL DVD/CD TUNER
TUNED VOLUME
L L

Enjoying multi-channel software

If you connected a surround back speaker, use this feature
to enjoy 6.1-channel playback for multi-channel sources
using the Dolby Digital Pro Logic IIx, Dolby Digital
Surround EX or DTS-ES decoders.
Press EX/ES on the remote control to switch
between 5.1- and 6.1-channel playback.
EX/ES
+10
AUTO
OFF
To select a decoder, press l / h repeatedly
when PLIIx Music (etc.) is displayed.
AUTO
When a signal (flag) that can be recognized by the unit is
input, the unit selects the optimum decoder for playing
back the signal in 6.1 channels. If the unit cannot
recognize the flag or no flag is present in the input signal,
it cannot automatically be played in 6.1 channels.
Decoders (select with l / h)
You can select from the following modes depending on the
format of the software you are playing.
PLIIx Music
For playing back Dolby Digital or DTS signals in 6.1
SLEEP
channels using the Pro Logic IIx decoder.
R
EX/ES
For playing back Dolby Digital signals in 6.1
channels using the Dolby Digital Surround EX
decoder.
DTS signals are played back in 6.1 channels using
the DTS-ES decoder.
OFF
For playing back Dolby Digital or DTS signals in 5.1
channels.
Decoder
(select with l / h)
PLI Ix Music
EX/ES