Troubleshooting - Yamaha RX-SL100RDS Bedienungsanleitung

Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, set this unit to the standby mode, unplug the power cord from the outlet, and
contact the nearest authorized YAMAHA dealer or service center.
General
Problem
This unit fails to turn The power cord is not connected or the
on when STANDBY/ plug is not completely inserted.
ON is pressed, or
The impedance setting is incorrect.
enters in the standby
mode soon after the
The protection circuitry has been
power has been
activated.
turned on.
This unit has been exposed to a strong
external electric shock (such as lightning
and strong static electricity).
No sound Incorrect input or output cable
connections.
Input Mode is set to dts or Analog.
No appropriate input source has been
selected.
Speaker connections are not secure.
The volume is turned down.
The sound is muted.
If you are playing an LD source, the
player may not output digital signals if the
LD source was not digitally recorded.
The Input Mode is set to Analog while
playing a source encoded with a DTS
signal.
Signals this unit cannot reproduce are
being received from a source component
e.g.: a CD-ROM.

TROUBLESHOOTING

Cause
Connect the power cord firmly.
Set the impedance to match your speakers.
Make sure all speaker wire connections on this unit
and on all speakers are secure and that the wire for
each connection does not touch anything other than
its respective connection.
Set this unit in the standby mode, disconnect the
power cord, plug it back in after 30 seconds, then use
it normally.
Connect the cables properly. If the problem persists,
the cables may be defective.
Select AUTO.
Select an appropriate input source by pressing
INPUT, then rotating VOLUME/SELECT or using
the input selector buttons.
Secure the connections.
Turn up the volume.
Press MUTE or any operation button on this unit to
cancel mute and adjust the volume.
Set the Input Mode to Analog.
Set the Input Mode to AUTO or dts.
Play a source whose signals this unit can reproduce.
TROUBLESHOOTING
Remedy
Refer to
page
—
10
9—11
—
12—13
44
19
9
—
20
44
44
—
51