Cleaning The Guide Rail; Checking And Cleaning The Drive Sprocket; Storage - AL-KO MT 36 Li Betriebsanleitung

Storage

Chain type File diameter
Oregon 91P033X
NOTE
Only remove a little material when
sharpening!
We recommend using a chain sharpen-
ing tool for sharpening your saw chain.
7.1.4

Cleaning the guide rail

1. Clean the guide rail, the groove of the guide
rail and the oil outlet openings regularly.
2. Use a flat file to remove the burrs that have
built up on the guide rail due to the saw chain.
7.2 Checking and cleaning the drive
sprocket
The load on the drive sprocket (05/2) is particu-
larly intense. Therefore, perform the following
tasks:
1. Check the teeth of the drive sprocket regu-
larly for wear or damage.
2. Clean the drive sprocket and guide rail at-
tachment with a brush.
NOTE
A worn or damaged drive sprocket reduces
the service life of the saw chain, and so the
drive sprocket should be renewed without
delay by the customer service.
442030_a
Top plate
angle
Rotational
angle of the
tool
5/32" 30°
Depth gauge setting
Down angle Head tilt angle
(55°)
Inclination Side plate angle
angle of the
tool
0°
8 STORAGE
Thoroughly clean the appliance after each use
and – if present – attach all covers. Store the ap-
pliance in a dry, lockable place out of the reach of
children.
Carry out the following jobs before intervals in
work lasting for longer than 30 days:
1. Empty the oil tank for the saw chain oil.
2. Remove the saw chain and guide rail, clean it
and spray it with rust-proofing oil.
3. Thoroughly clean the appliance and store it in
a dry place.
IMPORTANT!
Danger of damage to the appliance
Dried-on/sticky saw chain oil can lead to
damage to oil-channelling components
after lengthy storage.
■
Remove the saw chain oil from the
appliance before an extended period
of storage.
Depth
gauge set-
ting
80° 0.025"
File
29