Cleaning The Guide Rail; Checking And Cleaning The Drive Sprocket; Storage - AL-KO CSA 4020 Betriebsanleitung

GB
Chain type File diameter
Oregon 91P033X
NOTE
Only remove a little material when
sharpening!
We recommend using a chain sharpen-
ing tool for sharpening your saw chain.
7.1.4

Cleaning the guide rail

1. Clean the guide rail, the groove of the guide
rail and the oil outlet openings regularly.
2. Use a flat file to remove the burrs that have
built up on the guide rail due to the saw
chain.
7.2 Checking and cleaning the drive
sprocket
The load on the drive sprocket (05/2) is particu-
larly intense. Therefore, perform the following
tasks:
1. Check the teeth of the drive sprocket regu-
larly for wear or damage.
2. Clean the drive sprocket and guide rail at-
tachment with a brush.
NOTE
A worn or damaged drive sprocket re-
duces the service life of the saw chain,
and so the drive sprocket should be re-
newed without delay by the customer
service.
42
Top plate
angle
Rotational
angle of the
tool
5/32" 30°
Depth gauge setting
Down angle Head tilt angle
(55°)
Inclination Side plate angle
angle of the
tool
0°

8 STORAGE

Thoroughly clean the appliance after each use
and – if present – attach all covers. Store the ap-
pliance in a dry, lockable place out of the reach of
children.
Carry out the following jobs before intervals in
work lasting for longer than 30 days:
1. Empty the oil tank for the saw chain oil.
2. Remove the saw chain and guide rail, clean it
and spray it with rust-proofing oil.
3. Thoroughly clean the appliance and store it in
a dry place.
IMPORTANT!
Danger of damage to the
appliance
Dried-on/sticky saw chain
oil can lead to damage to
oil-channelling compon-
ents after lengthy storage.
■
Remove the saw chain
oil from the appliance
before an extended
period of storage.
Storage
Depth
gauge set-
ting
80° 0.025"
File
CSA 4020