Cleaning And Maintenance; General Cleaning; Cleaning Thetransfer Ribbon Roller - Carl Valentin Dynacode II 107 Kurzanleitung Und Hinweise Zur Produktsicherheit

Dynacode II

Cleaning and Maintenance

DANGER!
Risk of death by electric shock!
⇒
Disconnect the direct print module from power supply before performing any maintenance work.
NOTICE!
When cleaning the label printer, personal protective equipment such as safety goggles and gloves are recommended.
Maintenance task

General cleaning.

Cleaning transfer ribbon roller.
Cleaning printhead.
Replacing printhead.
Adjusting angle.
NOTICE!
The handling instructions for the use of Isopropanol (IPA) must be observed. In the case of skin or eye contact,
immediately wash off the fluid thoroughly with running water. If the irritation persists, consult a doctor. Ensure good
ventilation.
General Cleaning
CAUTION!
Abrasive cleaning agents can damage the direct print module.
⇒
Do not use abrasives or solvents to clean the outer surface of the label printer.
⇒
Remove dust and paper fuzz in the printing area with a soft brush or vacuum cleaner.
⇒
Clean outer surfaces with an all-purpose cleaner.

Cleaning theTransfer Ribbon Roller

A
74
Frequency
As necessary.
Each time the transfer ribbon is changed or when the printout
is adversely affected.
Each time the transfer ribbon is changed or when the printout
is adversely affected.
In case of errors in printout.
In case of an unequal use of the printhead.
A soiled print roll can lead to reduced print quality and can affect
transport of material.
•
Remove transfer ribbon cassette.
•
Remove deposits with roller cleaner and a soft cloth.
•
If the roller (A) appears damaged, replace it.
English