Eliet Major Anleitung Seite 74

• If the blades are sharpened regularly, a tool life in excess of 50 hours per cutting
edge is guaranteed.
• When one cutting edge has been used-up, the blade may be turned so it can be
used for another 50 operating hours. If both cutting edges have become blunt,
the blade must be replaced.
To turn the blades, proceed as follows.
Disconnect spark plug cable by way of precaution.
•
• Place the machine on the front base and the
steering handle in the same way as when the
blades are sharpened. Be careful not to spill
petrol from the reservoir.
• Remove the screen by pulling out the two sliding
pins. This will increase the accessibility to the
shredding chamber. Secure the rubber flap using
circlips.
• Before removing the blades, release and remove the two M8 bolts. If the bolts are
damaged, they should be replaced. The blades are pulled out with gripping
tongs.
Zone A : For the blades on the outermost blade
•
disks, proceed as follows.Remove a blade from
the left-hand side, rotate it through 180° and fit
it in the same position, but in the right-hand
blade disk. The blade from the right-hand blade
disk is rotated through 180 degrees and fitted in
the vacant hole in the left-hand disk. Repeat this
procedure for all blades of zone A (see figure).
Once all blades in zone A have been turned, recheck whether the chamfered
•
cutting edges point towards the centre of the shredding chamber and not
towards the wall plate. If this is not the case, two blades have not beeen turned
correctly.
74
11.5.6 Reversing and replacing the blades
Warning:
Wear gloves because the blades are razor-sharp!
For information:
When turning the blades, dismantle and reinstall one blade at a time. This
ensures the work is performed in an orderly manner.
A
B
A