Eliet Major Anleitung Seite 60

9.5.3 After switching off the engine
The engine may cut out due to overloading, wood being fed in too quickly or lack of
petrol. It is not possible to keep on restarting it. The following operations should be
carried out:
1. Check the petrol level in the petrol tank.
2. Remove all branches from the input opening.
3. Pull the starter cord briefly. This will determine whether the drive shaft for the
blades is still obstructed. Stop pulling as soon as you encounter resistance, and the
cord cannot be pulled any further. There is no point in pulling hard on the cord, as
this can only cause the cord to break or overload the starting mechanism.
4. If the drive shaft for the blades is stuck, the shredder housing should be emptied.
To this end, open the screen. The screen is secured by two sliding pins. Remove the
top sliding pin after removing the circlips. The screen can now be folded down.
5. Remove all wood chips and debris from the shredding chamber. Carefully refit the
screen and check whether this has been done correctly.
6. Lower the safety net and start up the shredder (as per the start up procedure
described in
7. Perform the work more carefully in future in order to avoid jamming the machine.
60
Warning:
If the machine topples over, petrol can leak out. In certain conditions petrol
can be highly flammable and very explosive. Petrol fire and explosion can
cause severe burns or damage to properties.
Warning:
The blades are razor-sharp, avoid injuring your hands. Wear gloves!
§ 9.4 Starting the engine).
(§ 9.2 Refuelling)