Dealer Tasks - Eliet Major Anleitung

8. Dealer tasks

When the machine has been removed from its packaging, it is not yet fully assembled.
It is the dealer's task to finish this assembly. A number of guidelines are listed below :
* Firstly, the steering handle is installed. This is secured in the holes provided by two M6
bolts. (use a 10 mm ring spanner)
* The hopper at the front of the input opening is unfolded and secured with the 2 (M6)
bolts, pinions and nuts respectively.
* The wheels are slid onto the wheel shafts. Some lubricating grease (Sunoco
Multipurpose LR-EP2, for instance) may be applied to the roller bearings beforehand.
Finally, the wheels on the shafts are locked using the Starlock caps supplied.
* The dealer adjusts the belt tension in accordance with the description in the
maintenance section of this instruction manual. Each ELIET dealer is responsible for
the long operating life of the ELIET machine. He will lubricate all hinge points of the
machine again before delivering the machine to the customer.
* The machine is packed without oil or petrol. The dealer will apply these in accordance
with the instructions in this manual (or the instructions in the engine manuals).
* For petrol engines, the engine speed is set at 3200 rpm.
* The dealer performs a test run on the machine and checks that everything works
correctly. (e.g.: safety net, emergency stop...)
* Finally the dealer ensures the guarantee card is completed and signed in order to
avoid disputes in any warranty cases. Please refer to the guarantee conditions for
further information.
52
Warning:
The ELIET dealer is obliged to instruct his customers on the operation of the
machine and, at the same time, make them aware of possible hazards which
may occur while working with the machine. He will carefully go through the
maintenance issues together with the new owner. He will repeat these
instructions till the new owner has fully understood everything.
As the manufacturer, ELIET wishes to re-emphasise that the dealer must
expressly point out to customers that they are to retighten the bolts for
the blades after the first 5 operating hours.
Caution:
In the case of a petrol engine, the dealer will pay particular attention to the
correct adjustment of the speed of the machine. If the speed has been set
too high, this will cause additional vibration which in turn will cause
increased wear in due course. If the speed has been set too low, the machine
will loose power.