Lubricants; Routine Checks Before Each Job; Visual Inspection; Checking The Oil Level In The Engine - Eliet Major Anleitung

11.3 Lubricants

Engine (0,75 l)
Hinge points (pivots)
Wheel shafts

11.4 Routine checks before each job.

11.4.1 Visual inspection

Check for deformation of parts, cracking of joints or too much play in parts.
If abnormalities can be established, the necessary repair work should be carried out.
Check whether the machine is running at the prescribed speed (3200 rpm) (a
revolution counter can be obtained from your ELIET dealer). Never attempt to change
the standard setting of the engine.

11.4.2 Checking the oil level in the engine

Refer to the 'General description' section in
oil dipstick and oil drainage and filler plugs.
Take a clean cloth.
•
• Pull the oil level dipstick out of the oil filler opening.
• Usually, the oil level cannot be correctly read immediately. Wipe the dipstick
clean, place it back in the oil filler opening, but do not tighten it.
• Pull the dipstick out again, and read the correct oil level.
• If the oil on the dipstick is between the minimum and maximum level, then there
this is sufficient oil.
If the oil level is too low it can be filled up via the oil filler plug. Only use the
recommended oil. Do not add too much at a time and regularly check the oil level.

11.4.3 Cleaning the air filter

The type of air filter can vary slightly depending on the make and type of engine.
•
• Locate the air filter underneath the black protective cap beside the petrol tank on
the machine.
Release the black protective cap.
•
• There are two types of filter. As well as the common sponge filter, there is a filter
which consists of laminated paper like the air filter in a car.
• The sponge filter can be cleaned by rinsing it out with some petrol and blowing
compressed air through it.
SUNOCO SUPER DENALUBE
SAE 20 W 50 API SF / CC
NOVATIO WHITE SUPREME GREASE
SUNOCO VET MULTI-PURPOSE LR - EP2
§ 6. Main parts for possible locations of the
67