The Menu; Operating The Menu - Mettler Toledo BPA224 Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

METTLER TOLEDO BPA224 Scales

Weighing with limit values

Weighing in Weighing Mode is made easier for you by the two LEDs above the UNDER and OVER symbols

as well as a beep. The behavior of the two LEDS and the beep depend on the respective setting in the menu

(Chapter 4.2, menu item S3). The table below shows how the two LEDs and the beep behave for various

settings in menu item S3.

S3 =

No load on balance

UNDER OVER

The menu

The menu can be used to change the settings of the scale and activate functions. The menu consists of

two parts, the user menu and service mode (see overview in Chapter 4.2). The user menu contains

frequently used settings and functions and is easy to call up. Service mode provides the same possibilities

as the user menu as well as additional functions for the service technician. To call up service mode a tool

is required.

4.1

S1 OFF

Load < lower limit value Load between limit values Load > upper limit value

UNDER OVER

Calling up the user menu

With the scale switched off, press the a key and hold it down.

Switch on the scale with the c key.

"Setup" appears briefly in the display and then the first menu block of

the user menu ("S1") appears.

Calling up service mode

With the scale switched on, remove the cover of the storage battery

underneath the scale (6 screws). Remove the calibration plate (2

screws). To remove the calibration plate, the sticker has to be

destroyed which covers one of the two screws.

Use a small flat-tip screwdriver to short-circuit the two contacts in the

rectangular opening (see arrow).

UNDER OVER

Inhaltsverzeichnis