Controls And Connections - Castolin Eutectic TotalArc2 3000 Betriebsanleitung/Ersatzteilliste

Controls and connections

Power source TotalArc² 3000
Fig.3 Front view of power source TotalArc² 3000
Fig.4 Side view of power source TotalArc² 3000
Central torch connector ... for connecting up the welding
torch
- Current socket with bayonet latch ... for
- connecting the earth cable in MIG/MAG welding
- current connection for TIG welding torch
- connecting hand-held electrodes or the earth cable in
manual electrode welding (depending on the type of
electrode being used)
- Current socket with bayonet latch ... for
- connecting the earth cable in TIG welding
- connecting hand-held electrodes or the earth cable in
manual electrode welding (depending on the type of
electrode being used)
Fig.5 Rear view of power source TotalArc² 3000
Torch control connection socket ... for connecting the
torch control plug
Remote control connection socket ... standardised con-
nection socket
Blanking cover
Mains switch ... for switching the power source on and off
Shielding gas connection socket
Mains cable with strain-relief device
Gas-test button / wire-inching button
- gas-test ...for setting the required gas-flow rate on the
pressure regulator. After you press up and hold this
button, gas will flow out.
- wire-inching ... for feeding the wire electrode into the
torch hosepack with no flow of gas or current.
Wire-spool holder with braking device ... for holding
standardised welding-wire spools weighing up to 16 kg
4-roller drive
Screw cap / filler neck for coolant
Coolant inspection window
Fuse for coolant pump
Motor-shaft lead-through of the coolant pump
Plug-type connection for water forward flow (black)
Plug-type connection for water return flow (red)
Tank draining hose (inside housing)... for emptying the
coolant reservoir
34