Pilz PKB-M Bedienungsanleitung Seite 46

www.dplusa.fr
Operation
Peak Cur
Peak current
XXX.XA
XXX.X
So as not to damage the free wheel diode, the switch-on current should
not exceed 100 A.
INFORMATION
To reduce the switch on current, increase safety time t
To reduce the switch off current, increase safety time t
the life of the brake contactor.
N XX.XA
Braking current
A YY.YA
XX.X
YY.Y
Max XXX#
Standstill threshold
A YYY# Z
Only on units with standstill detection
XXX
YYY
Z
N XXX°Ci
Heatsink temperature
A YYY°Ci
XXX
YYY
N XXXkΩe
Motor temperature
A YYYkΩe
XXX
YYY
16
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
DETECTION ET AUTOMATISME - 17 Rocade de la Croix St Georges - 77600 BUSSY ST GEORGES - Tél : 01.64.66.90.00 - Fax : 01.64.66.98.01 - mail : infos@dplusa.fr
Peak value of the braking current when the brake contactor
energises or de-energises (switching current of the brake
contactor)
set braking current
measured effective value of the braking current
highest level of the standstill signal
current level of the standstill signal
1, 2, 3 or 4; Step in the control logic (see standstill menu and
sub-menu)
set maximum value of the heatsink temperature
current value of the heatsink temperature
set maximum value of the external PTC-thermistor
current value of the external PTC-thermistor
.
v1
. This increases
v3
PKB-M, PKB-MS Operating Manual