Pilz PKB-M Bedienungsanleitung Seite 44

www.dplusa.fr
Operation
Process
Process data
Data
START
Reset contact monitoring
XXXXXXXX
XXXXXXXX Dynamic: A braking process can be interrupted by opening
E-Halt
Braking with overtemperature
XXX
XXX
E-Reset
Error-reset
XXXXXX
XXXXXX Auto: Fault is reset automatically
Slave
Master-Slave operation
XXX
XXX
ext.Temp
Motor temperature monitoring
XXX
XXX
int.Temp
Heatsink limit temperature
XXX°C
XXX
Contrast
LCD contrast
XXXX#
XXXX
14
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
DETECTION ET AUTOMATISME - 17 Rocade de la Croix St Georges - 77600 BUSSY ST GEORGES - Tél : 01.64.66.90.00 - Fax : 01.64.66.98.01 - mail : infos@dplusa.fr
the reset contact
Static: A braking process cannot be interrupted again by
opening the start contact.
Off: A braking process is interrupted by overtemperature, the
brake goes into fault.
On: A braking process continues despite overtemperature,
after that the brake goes into fault.
Manuel: Fault must be reset manually (press ESC and ENTER
simultaneously).
Off: Stand-Alone-operation
On: Operation with Slave-brake (symmetrical braking)
Off: without motor temperature monitoring
On: The value of the connected PTC-thermistor at the
terminals Z31 and Z32 is monitored and if one of the internally
programmed thresholds is exceeded, the braking operation and
the motor enable are locked.
Maximum heatsink in
LCD contrast value, can be saved (retentive) in this menu
o
C
PKB-M, PKB-MS Operating Manual