English
Starting/stopping the rotary
brushes
Pull the lower lever;
Rotary brush drive ON
*
Release the lower lever;
Rotary brush drive OFF
*
Measuring out the cleaning agent
Press the upper lever;
Cleaning agent feed ON,
*
indicator light is on and green
(see arrow)
Release the upper lever;
Cleaning agent feed OFF
*
Steering machine
Turn the pushing handle to the LEFT
Cleaner moves to the LEFT,
*
Turn the pushing handle to the
RIGHT
Cleaner moves to the RIGHT
*
BR VS 400
Changing the rotary brushes
Remove the tank
–
Carefully lay the cleaner down
–
Always refit two rotary brushes of
–
the same type
Press down and suspend the rotary
brushes
Remove the rotary brushes from the
gearing
Lay down the rotary brush on the
–
drive side (gearing)
Dismantle the second rotary brush
–
as described
Fit on a new rotary brush with the
gearing located on the drive
Press the rotary brush down and
–
place it into the thrust bearing
Install the second new rotary brush
–
as described
Check that the rotary brushes are
–
in the correct position
Position the cleaner vertically
–
14
EACH TIME BEFORE OPERATION
Check the cleaner and especially
–
the power cable for damage
Checked the rotary brushes for the
–
presence of foreign objects
Fit the rotary brush that is suitable
–
for the job
If necessary top up the cleaning
–
agent solution in the tank
Connect the plug to the power
–
cable
Hang the strain-reliever
–
Plug the cable into the power
–
socket
Check that there are no obstacles
–
in the area to be cleaned
See the Operation Chapter for the
*
description
OPERATION
Warning!
The cleaner must always be in motion
during operation!
Do not work on one spot as this may
damage the floor covering!
Do not start an unfilled appliance on
delicate floors!
Prior to start-up, tilt unit, activate
cleaning agent supply and switch on
drive unit for brush rollers.