English
DEVICE ELEMENTS
1. Unlocking thrust clip
2. Water suck-off socket (accessory)
3. Recessed grip
4. Castors
5. Splash guard (vertically adjustable)
6. Tank fill opening
7. Sliding U-shaped protection
1. Clip for water pump
2. Clip for brush motor
3. Power cable
4. Strain relief
5. Tank
6. Releasing brushes
7. Support stirrup
8. Brushes
9 . Hinge
10. Turning handle for hinged clip
BR VS 400
FIRST INSTALLATION
Installing the pushing handle
Position the lower half of the pushing
handle vertically
Adjust the upper half of the pushing
handle and fix it with the knurled
screw
Note:
Do not jam cable when fitting
Install rotary brushes
Carefully lay the cleaner down
–
Always use two rotary brushes of
–
the same type
Place the rotary brush with gearing
onto the drive
Press the rotary brush down and
–
place it into the thrust bearing
Install the second rotary brush as
–
described
Check that the rotary brushes are
–
in the correct position
Position the cleaner vertically
–
12
Install the tank
Place the tank on the cleaner
OPERATION
Fill the tank
Note:
Observe the dosing
recommendations of the cleaning
agent's manufacturer and mix the
cleaning agent solution thoroughly.
Take care when handling cleaning
agents!
Comply with the safety
*
recommendations of the cleaning
agent's manufacturer
Rinse splashes in eyes or on the
*
skin out or off with plenty of clean
water
Call a doctor immediately
*
Wash contaminated clothing with
*
water