6.4. DC Current Measurement
1.
Connect the black test lead to the COM jack and the red test lead
to the V/Ω/ mA-jack for a max. of 200 mA. For a maximum of 10 A,
move the red test lead to the 10 A jack.
2.
Set the function switch to the DC A range to be used and
connect the test
measurement.
Note:
1.
If the current range is not known beforehand, set the FUNCTION
switch to the highest range and work down.
2.
When only the figure "OL" is displayed overrange is being
indicated and the FUNCTION switch must be set at higher
range.
3.
Caution: The maximum input current is 200 mA, or 10 A
depending upon the jack used. Excessive current will blow the
fuse which must be replaced.
4.
Replace the blown fuse only with a fuse with the same ratings and
dimensions.
leads
in series
-33-
with
the load
under