Yamaha PLG100-VL Bedienungsanleitung Seite 27

4. Breath Control ............................Settings: BC (Breath Control), Exp (Expression)
Specifies the MIDI control change number to be used for breath control when breath
control is applied from a breath controller or WX-series Wind MIDI Controller. When
"BC" is selected control change number "02" (breath control) is used for breath con-
trol. When "Exp" is selected control change number "11" (expression) is used for
breath control.
• This parameter is also available for the breath controller data transmitted from a device other than the WX-
series.
• This parameter is effective only when "BC/WX" is selected from Breath Mode.
5. Breath Curve ............................................................................. Setting: -16 ... +16
Determines the relationship between breath control data received from a breath con-
troller, WX-series Wind MIDI Controller (via the BT7 and MIDI IN connector), and
the actual amount of breath variation applied. Minus settings result in a large breath
variation with a relatively small amount of breath pressure applied to the controller,
while plus settings required a greater range of input breath control values to produce
the same degree of breath variation.
• This parameter is also available for the breath controller data transmitted from the device other than WX-
series.
• The settings made here is effective only when "BC/WX" is selected from Breath Mode.
• Connection Between WX-series and "mother" tone generator/sound card
WX5
WX IN
• When you use a sound card built into PC...
To control PLG100-VL using WX-series Wind Controller, select "SW1000 #1 Synthesizer" for the
MIDI Thru setting in the System Setup dialog of the "XGworks."
BT7
MIDI MIDI
OUT IN
VL System Parameters
MU100R
27