Identification; Product Description And Type Designation; Product Marking; Preparing The Product For Use - Videotec PTH300 Bedienungsanleitung

• Use only original spare parts. Non-original spare
parts could cause fire, electrical discharge or other
hazards.
• Before proceeding with installation, check the
supplied material to make sure it corresponds
to the order specification by examining the
identification labels (4.2 Product marking, page 4).
• A power disconnect device must be included
in the electrical installation, and it must be very
quickly recognizable and operated if needed.

4 Identification

4.1 Product description and type
designation
Pan & Tilt PTH300 is obtained through solid pressure
casting of painted aluminium with epoxy powder.
Pan & Tilt can rotate horizontally at a speed of 6°/s
(maximum tour of 330°) and vertically at a speed of
3°/s (maximum tour of 360°). The autopan function
can be used for limited periods of time.
The PTH300P version avails of potentiometers to save
the various preset positions by the control unit.

4.2 Product marking

See the label attached to the product.
4
5 Preparing the product for
use
Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.

5.1 Unpacking

When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
When returning a faulty product we recommend
using the original packaging for shipping.
Keep the packaging in case you need to send the
product for repairs.
5.2 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Pan & Tilt
• Bracket for housing
• Bolts and screws
• Instruction manual
5.3 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
MNVCPTH300_1643_EN