Identification; Product Description And Type Designation; Product Marking; Preparing The Product For Use - Videotec NTM Bedienungsanleitung

4 Identification

4.1 Product description and type
designation
This housing for thermal camera provides the vision
also in complete darkness, fog, rain, smoke or for
long-range distances.
The germanium window is external non-scratch
treated, Hard Carbon Coating (DLC), and internal
antireflection; the spectral range is from 7.5 to 14μm.
The AISI 316L stainless steel construction allows the
installation in environments with highly corrosive
external agents, such as marine, industrial or
chemical environments.
The NTM housing can be installed on NXPTH Pan &
Tilt head, to obtain a complete positioning system.

4.2 Product marking

See the label attached to the product.
5 Preparing the product for
use
Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.

5.1 Unpacking

When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
4
5.2 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Housing
• Housing equipment:
• Allen wrench
• Spacers
• Bolts and screws
• Instruction manual
5.3 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
When returning a faulty product we recommend
using the original packaging for shipping.

6 Installation

6.1 How to open the housing

Unscrew the bolts on the rear flange, using the allen
wrench supplied.
Fig. 1
Slide out the rear cover plate of the housing, taking
care to leave the sealing washer in its seating.
Fig. 2
MNVCNTM_1628_EN