Check And Change The Oil At The Headstock, Feed Gear And Lock Case; Additional Lubrication Points On The Lathe - Holzmann ED 1000N Originalbetriebsanleitung

15.1.1 Check and change the oil at the headstock, feed gear and lock case

Headstock
15.1.1

Additional lubrication points on the lathe

For the lubrication of all in the following figure drawn smudges and guides, a lubricating oil is to
be used with viscosities between SAE50 and SAE 80. The lubrication of lubricating points and
guides should be performed at least before each use.
HOLZMANN MASCHINEN GmbH
Feed gear
Oil level sight glasses
Oil drain plug
www.holzmann-maschinen.at
METALLDREHMASCHINE / METAL TURNING LATHE ED 1000N / ED 1000NDIG
fillercap
MAINTENANCE
Lock case
Oil level sight
glasses
Seite 48