Remaining Risk Factors; Assembly; Scope Of Delivery - Holzmann ED 1000N Originalbetriebsanleitung

12.5

Remaining risk factors

It is important to ensure that each machine has remaining risks.
In the execution of all work (even the simplest) greatest attention is
required. A safe working depends on you!
Even if they meet all the safety rules and if used properly, the following residual risks are noted:
 Risk of injury to the hands / fingers by the rotating lathe chuck during operation.
 Risk of injury from sharp edges of the workpiece, especially in non-fixed with appropriate tools
/ device workpiece.
 Injury: hair and loose clothing, etc. can be recorded and wound up by the rotating lathe
chucks! Serious injury! Always observe safety regulations with respect. Workwear.
 Risk of injury from contact with live components.
 Risk of injury by tilting the machine.
 Risk of injury due to dust emissions, treated with harmful agents workpieces.
 Risk of being cut by untrimmed drill edges.
 Injury to the eye by flying debris, even with goggles.
These risks can be minimized if all safety regulations are applied, the machine is properly
maintained and serviced the machine as intended and is operated by properly trained personnel.
Despite all safety devices and remains their healthy common sense and your corresponding
technical suitability / training of the use of a machine is the most important safety factor!
13

ASSEMBLY

13.1

Scope of delivery

The ED 1000N / ED 1000NDIG is delivered fully assembled in principle.
You only need to install the supplied digital display on the bracket to the lathe and connect to the
connector on the machine.
In addition, the tool is included in the case.
 3-jaw chuck with interchangeable jaws 160mm
 Face chuck
 chuck guard
 substructure
 bulkhead
 Steady rest
 Follow rest
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
METALLDREHMASCHINE / METAL TURNING LATHE ED 1000N / ED 1000NDIG
W A R N I N G
 chip tray
 4-way tool post
 Change gear kit - 14, 15, 22, 26, 38, 44, 52
 Fixed tips MK3
 Spindle cover
 Tools
ASSEMBLY
Seite 36