Lubrication; Headstock; Feed Gear; Lock Case - Holzmann ED 1000N Originalbetriebsanleitung

50 Hz
Plug 400V:

13.3.1 Lubrication

Check the lubrication of the following parts before working on the machine:

13.3.2 Headstock

The bearing of the spindle is situated in an oil bath. Make sure that the oil level is always reached
the mark of the sight glass. To change the oil you drain the oil through development of remote
drain plug at the bottom of the headstock. To replenish the oil again, remove the cover of the
headstock. Check the oil level regularly. The first oil change should be performed after 3 months,
then you should change the oil once a year. (see 15.1.1)

13.3.3 feed gear

The first oil change should be made after three months, after a sufficient change once a year.
(see 15.1.1)

13.3.4 Lock case

The oil bath is filled with Shell Tellus 32. Check the oil level using the oil sight glass on the front
page. The first oil change should be made after three months, then changes once a year is
sufficient. To drain the oil, remove the drain plug at the bottom of the skirt. (see 15.1.1)

13.3.5 Other parts

Additional lubrication points can be found on the drive shaft, the hand wheels to the lock case and
the tailstock. Lubricate them regularly with a grease gun.
Apply a thin coat of oil on the machine bed and all other exposed parts like on the tailstock, screw
cutting, etc. once a day.

13.3.6 Retraction prior to initial

The retraction should be performed with the lowest screw speed. Let the machine at this speed
for about 1 hours walk. Check out irregularities, such as unusual noises, imbalances, etc. If
everything is ok, you gradually increase the speed. The highest speeds may be driven only after
10 hours of operation.
HOLZMANN MASCHINEN GmbH
5-wire:
with
N-conductor
www.holzmann-maschinen.at
METALLDREHMASCHINE / METAL TURNING LATHE ED 1000N / ED 1000NDIG
<44 m
<70 m
<105 m
2,5 mm 2
4,0 mm 2
6,0 mm 2
4-wire:
without
N-conductor
ASSEMBLY
Seite 40