Prepartory Activities; The Workplace; Transport / Unloading The Machine; Assembly - Holzmann ED 1000N Originalbetriebsanleitung

13.2

Prepartory activities

13.2.1 The workplace

Beachten Sie dabei die Sicherheitsanforderungen aus Kapitel 2 sowie die Abmessungen der
Maschine aus Kapitel 1. Notice. Attachment to the ground To do this, use bolts! The connection to
the ground to ensure a safe workplace. Choose a suitable place for the machine. Observe the
safety requirements of Chapter 12 and the dimensions of the machine from Chapter 11.2
The selected location must ensure an appropriate connection to the electrical grid.
Make sure that the floor can support the weight of the machine, the machine must be in contact
at all points.
You also need a minimum distance of 0.8 m around the machine completely secure to ensure safe
working.

Transport / unloading the machine

To transport the machine is best suited to a sling with sufficient capacity. Place the belt slip grip
around the machine and make sure that it can not be damaged. Lift the metal lathe carefully with
the help of a crane or other suitable lifting device on. Is recommended when lifting with belts to
use hooks. Align the belt length so that, when lifting the machine is level and stable. Avoid the
use of slings, as they risk damaging the feed rod or lead screw. Lift the lathe and carefully place
it on the floor. (see 12.2.1)
Vergewissern Sie sich ebenfalls, dass der Aufstellort dem Gewicht der Maschine
standhält, speziell bei Aufstellung der Maschine oberhalb des Erdgeschoß. Check
that the belt on the body of the machine are well secured.
The lifting and transportation of the machine may only be carried out by qualified
personnel carried out with appropriate equipment.
Note that the selected lifting equipment (crane, forklift, sling, etc.) are in perfect
condition.
Also make sure that the location of the weight of the machine can withstand,
especially when installing the machine above the ground floor.
To maneuver the machine in the packaging is also a pallet truck or a forklift can be used.

13.2.2 Assembly

Place the machine on the base
Now lift the machine carefully as described under item 6 on the height of the undercarriage. The
fixation positions are shown in the following figure.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
METALLDREHMASCHINE / METAL TURNING LATHE ED 1000N / ED 1000NDIG
W A R N I N G
ASSEMBLY
Seite 37