Maintenance - Holzmann ED 1000N Originalbetriebsanleitung

15

MAINTENANCE

Don't clean or do maintenance on the machine while it is still connected to the
power supply:
Damages to machine and injuries might occur due to unintended switching on of
the machine!
Therefore: Switch the machine off and disconnect it from the power supply be-
fore any maintenance works or cleaning is carried out
The machine does not require extensive maintenance. If malfunctions and defects occur, let it be
serviced by trained persons only.
Before first operation as well as later on every 100 operation hours you should lubricate all con-
necting parts (if required, remove beforehand with a brush all swarfs and dust).
Check regularly the condition of the security stickers. Replace them if required.
Check regularly the condition of the saw band and the saw band guide.
The good condition and perfect adjustment of the guiding rollers is essential for a smooth band
guidance and a clean cut.
Store the machine in a closed, dry location.
Changing the belt
First, open the two screws on the cover and remove it.

Loosen the Allen screw and remove the pulley.

Now you can remove the belt.

Go for the installation before mutatis mutandis

backwards.
With the screws on the motor mount fan belt can be tightened.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
METALLDREHMASCHINE / METAL TURNING LATHE ED 1000N / ED 1000NDIG
A T T E N T I O N
MAINTENANCE
A
Seite 47