Dismoun Ng, Return And Disposal - LR-Cal LPC 200 Bedienungsanleitung

MANUAL
LR-
8.1 Reset to factory se ng (RESET)
If the problems above cannot be solved using the recommended measures, then, by
pressing the keys
(RESET) can be made.
Following the comple on of the "RESET" the calibrator must be s
turned on again a er approx. ive seconds.
CAUTION!
If faults cannot be eliminated by means of the measures listed above, the
instrument must be shut down immediately, and it must be ensured that
pressure and/or signal are no longer present, and it must be prevented
from being inadvertently put back into service. In this case, contact
the manufacturer. If a return is needed, follow the instruc ons given in
chapter "9.2 Return".

9. Dismoun ng, return and disposal

WARNING!
Residual media in dismounted LPC-2 pressure sensors or (at model
LR-Cal
the environment and equipment.
Take su cient precau onary measures.
9.1 Dismoun ng
LR-Cal LPC 200-T: Let the temperature sensor cool down su ciently before dismoun ng!
Only disconnect the LPC-2 reference pressure sensor once the system has been
depressurised!
9.2 Return
WARNING!
Strictly observe when shipping the
indicator and the sensors:
All
Leitenberger GmbH must be free from any kind of hazardous substances
(acids, bases, solu ons, etc.).
When returning the
transport package.
Tel. +49 (0) 7121-90920-0 • Fax +49 (0) 7121-90920-99 • DT-Info@Leitenberger.de •
Cal Cal
LPC 200 + LR-
and "FUNC" at the same me, a reset to the factory se ngs
f
LPC 200-T) temperature sensor can result in a risk to persons,
ff
calibrators and sensors delivered to
calibrator and the sensors, use the
DRUCK & TEMPERATUR Leitenberger GmbH • Bahnhofstr. 33 • D-72138 Kirchentellinsfurt • GERMANY
LPC 200-T
ff
Cal
LR- LPC 200 /
DRUCK & TEMPERATUR
original packaging or a suitable
www.LR-Cal.net
70
witched o f, and then f
Cal
LR- LPC 200-T
• www.druck-temperatur.de