LR-Cal LPC 200 Bedienungsanleitung Seite 62

MANUAL
LR-
6.4.4 Info screen
Via the MODE key dif erent func ons can be superimposed, e.g. the func on: Info (
Ac va on of the Info screen
Pressing the MODE
* If you are in a different measuring mode than the standard measuring mode, press the
MODE key un l the
1
2
3
4
5
6
7
8
1) Serial number of the
2) Current Firmware version in the instrument
3) Internal sensor number of the currently-connected
4) Pressure type for the currently-connected sensor LPC-2
5) Accuracy in % FS of the currently-connected sensor LPC-2
6) Lower limit of the measuring range for the currently-connected sensor LPC-2
7) Upper limit of the measuring range for the currently-connected sensor LPC-2
8) Calibra on date of the currently-connected sensor LPC-2
Return to the standard measuring mode by pressing the MODE key several
Mode
mes.
6.5 Pressure units
Via the UNIT key, depending on the measuring range of the current
units bar, mbar, kPa, psi, mmHg, inHg or kg/cm² can be selected.
Press the UNIT key un l the required unit is displayed (ring-shi ).
6.6 Measurement signal processing
The standard value for the ilter for the measuring signal processing/smoothing is a factor
of "3" and can only be altered, to a value between 1 and 5, using the PC-so ware LPC-Cal
so ware. (Op onal available for
1 = no ilter, ... , 5 = high ilter f
Tel. +49 (0) 7121-90920-0 • Fax +49 (0) 7121-90920-99 • DT-Info@Leitenberger.de •
Cal Cal
LPC 200 + LR-
f
key four mes* (directly within the standard measuring mode)
Info screen appears on the display.
Info screen
Cal
LR- LPC 200 /
f
Cal
LR- LPC 200
f
DRUCK & TEMPERATUR Leitenberger GmbH • Bahnhofstr. 33 • D-72138 Kirchentellinsfurt • GERMANY
LPC 200-T
Cal
LR- LPC 200-T
pressure
, included in delivery of
62
INFO
sensor LPC-2
LPC-2 pressure sensor, the
Cal
LR- LPC 200-T
www.LR-Cal.net • www.druck-temperatur.de
).
.)