LR-Cal LPC 200 Bedienungsanleitung Seite 51

4.4.1 Connec on of the
The calibrator
electrically using a separate connec ng cable. When exchanging the sensor, use the
8-pin plug connector at the sensor.
or
DRUCK & TEMPERATUR Leitenberger GmbH • Bahnhofstr. 33 • D-72138 Kirchentellinsfurt • GERMANY
Tel. +49 (0) 7121-90920-0 • Fax +49 (0) 7121-90920-99 • DT-Info@Leitenberger.de •
LR-
LPC-2
CAUTION!
Only use model
sensors could damage both the
and the reference pressure sensors.
Switch the calibrator f
Before switching the instrument on, connect the sensor, otherwise it
may not be correctly iden ied by the instrument. The iden ica on of
the LPC-2 reference pressure sensors can take up to 60 seconds.
For gauge or rela ve pressure sensors, there is a pressure-equalising
vent in the top of the sensor under the plas c cover. This vent (with
integrated membrane) must remain clear, without fail!
CAUTION!
Only ever use the original
opera on of LPC-2 reference pressure sensors.
and the reference pressure sensor are connected to each other
Calibrator
LR-Cal LPC 200
LR-Cal LPC 200-T
Cal Cal
LPC 200 + LR-
reference pressure sensor
LPC-2 reference pressure sensors! Using other
LR-Cal
o f before changing sensors.
f
LEITENBERGER
Connec on between
instrument and sensor
via connec ng cable
www.LR-Cal.net
51
MANUAL
LPC 200-T
LPC 200 LPC 200-T / calibrator
f
connec ng cable in the
Reference pressure
sensor LPC-2
• www.druck-temperatur.de