LR-Cal LPC 200 Bedienungsanleitung Seite 50

MANUAL
LR-
4.3 Electrical connec ons to the calibrator
All electrical connec ons are located along the top edge of the
(see picture below).
Connec on for interface adapter
WARNING!
Only original
electrical connec ons. (Only the
input/charger socket; and only a
interface socket).
DANGER!
The
any electrical connec on. In addi on, the supply voltage marked on the
power supply unit must match the local mains voltage.
4.4 eference pressure sensor R
For the LR-Cal LPC 200 LPC 200-T
(with measuring ranges from 400 mbar up to 1,000 bar with an accuracy of 0.025 %, and
measuring ranges over 1,000 bar up to 6,000 bar with an accuracy of 0.1 %) which can
be interchanged quickly and without tools. When the
pressure sensor LPC-2
is needed.
Up to ten
LR-
Tel. +49 (0) 7121-90920-0 • Fax +49 (0) 7121-90920-99 • DT-Info@Leitenberger.de •
Cal
LPC 200 + LR-
Pressure sensor
LEITENBERGER
calibrator must be switched o f before connec ng or disconnec ng
LPC-2
/ , there are many reference pressure sensors to choose from,
a ached is recognised automa cally, so that no further con igura
LPC-2 reference pressure sensors are supported by one
Cal Cal
LPC 200 / LR-
DRUCK & TEMPERATUR Leitenberger GmbH • Bahnhofstr. 33 • D-72138 Kirchentellinsfurt • GERMANY
Cal
LPC 200-T
Power connec on
connec on
components should be connected to any of the
LEITENBERGER
LEITENBERGER
f
calibrator
LPC 200-T calibrator.
50
LR-Cal LPC 200 LPC 200-T /
ba ery charger to the mains
USB connec ng cable to the
is switched on, the refer
f
www.LR-Cal.net • www.druck-temperatur.de
ence
on