Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.3 Recalibra on
DKD/DAkkS er icate -
C
We recommend that the instrument is regularly recalibrated by the manufacturer, with
me intervals of approx. 12 months. Every factory recalibra on includes, addi onally, an
extensive free-of-charge check of all system parameters with respect to their compliance
with the speciica on. The basic se ngs will be corrected if necessary.
8. Faults
Display
low BAT
Sensor
Overlow
No display
or strange
symbols, device
is not respond-
ing to input
No display
No display
DRUCK & TEMPERATUR Leitenberger GmbH • Bahnhofstr. 33 • D-72138 Kirchentellinsfurt • GERMANY
Tel. +49 (0) 7121-90920-0 • Fax +49 (0) 7121-90920-99 • DT-Info@Leitenberger.de •
Cal
LR-
For informa on on returning the calibrator and its sensor(s)
see chapter "9.2 Return".
f
s Factory
Cer icates:
f
Causes
The rechargeable ba ery's capacity is
less than 10 %.
The current pressure value is outside
the measuring range of the model
LPC-2 reference pressure sensor
Malfunc on during opera on.
The instrument is not detected by the
PC.
When switching the instrument on,
a er 10 seconds no measured value
is displayed, but instead, the whole
display is dark.
The display is dark and the recharge-
able ba ery cannot be charged via the
ba ery charger.
Cal
LPC 200 +
LR-
Measures
Recharge the internal rechargeable
ba ery using the ba ery charger.
Adjust the pressure immediately and
appropriately.
Switch of the instrument and switch
on again a er 5 seconds.
Check whether the USB interface
is connected correctly and USB is
ac vated in the
6.8.2)
Recharge the internal rechargeable
ba ery using the ba ery charger.
Check that the ba ery charger is
connected properly, and also check
(using appropriately quali ied person
nel) that the power supply voltage is
correct.
www.LR-Cal.net
69
MANUAL
LPC 200-T
calibrator
(see chapter
f
• www.druck-temperatur.de
-
Werbung
Inhaltsverzeichnis
