LR-Cal LPC 200 Bedienungsanleitung Seite 59

6.4 Measuring modes
6.4.1 Standard measuring mode
Approx. 3 seconds a er switching on the
pressure sensor connected correctly, the "Standard measuring mode" display appears
(see igure below). It displays the current measured value, the unit and pressure type of f
the currently-connected pressure sensor and addi onally a bar graph and the charge
level of the rechargeable ba ery.
4
1. Ba ery level display
2. Current pressure measured value
3. Current unit and type of pressure
4. Bar graph
6.4.2 Measuring mode incl. MIN/MAX func on
Via the MODE
func on ( MIN/MAX
Ac va on of the MIN/MAX func on
Pressing the
* If you are in a different measuring mode than the standard measuring mode, press the
MODE key un l the measuring mode with the MIN/MAX func on appears on the display.
DRUCK & TEMPERATUR Leitenberger GmbH • Bahnhofstr. 33 • D-72138 Kirchentellinsfurt • GERMANY
Tel. +49 (0) 7121-90920-0 • Fax +49 (0) 7121-90920-99 • DT-Info@Leitenberger.de •
LR-
If the LPC-2 sensor has not been calibrated with the
"Uncalibrated Sensor" will appear on the display. Use of the sensor is
thus not permi ed.
Standard measuring mode
key diferent func ons can be superimposed, e.g. the
).
MODE key once* (directly within the standard measuring mode).
Cal Cal
LPC 200 + LR-
calibrator , with the
www.LR-Cal.net
59
MANUAL
LPC 200-T
LPC-2 reference
calibrator , the message
1
2
3
MIN and MAX
• www.druck-temperatur.de