Id To Pc; Reading Out And Saving The Data In The Device - Herth+Buss AirGuard Bedienhinweis

Operating Instruction

6.0 ID to PC

6.1 Reading out and saving the data in the device

Thisfunctionallowsyoutosavethevalues
of up to five wheel sensors on a vehicle in
the device and then transfer these to a PC
using our "ID to PC" software.
TIP
Savethevaluesinyourcustomerfile
orprintthemoutforyourcustomer.
Number of wheels:
Youcanonlysavesensordatafortheprint
function ID TO PC after setting WHEEL: 4 un-
der Settings in advance. Please first select
thevalue4forthenumberofwheelsinthe
settings menu.
Please note:
If the wheel value is set to 1 in the
settings, you can perform a normal
sensor diagnosis of a single sensor
on the vehicle. The device will not store
any wheel sensor data, however.
51
Function selection:
Use the arrow buttons to select DIAGNOSE
SENSORandpresstheenterkeyforthedi-
agnosis.
Scanning the ID of the 4 wheels:
The display will show the image of a vehi-
cle with 5 wheels (including spare wheel).
Please use the arrow buttons to select the
respective wheel and diagnose by pressing
theenterkey.
Please note:
Tyres that have not yet been diagnosed
will "flash" in the image. A "fixer" tyre is
pre-diagnosed and the value is saved.
95990001
EN