Cleanmaxx PC-P003W Gebrauchsanleitung Seite 24

EN
■ Switch the device off after each surface has been cleaned as this will considerably
increase the operating time on each battery charge.
■ Test the wiping attachment on a non-visible spot before using it on sensitive (high-
gloss) surfaces.
■ Do not use the device when it is connected to the charger.
1. Depending on whether you wish to use the device as a hand-held or fl oor vacuum
cleaner, insert the handle rod or detach it.
2. Place one of the nozzles into the suction opening. However, you can also use the
cordless vacuum cleaner without a nozzle.
6. Empty the collecting container after use and clean its insert and the fi lter on a regular
basis (see the "Cleaning the Device and Accessories" chapter). Also charge up the
battery (see the "Charging Up the Battery" chapter).
7. Store the cordless vacuum cleaner in a cool, dry indoor room out of the reach of
children and animals.
Cleaning Windows and Other Smooth Surfaces
1. Prepare the spray bottle: Stretch the wiping cloth onto the wiping attachment and
secure it in place with the Velcro fastener.
24
3. Press the On / Off switch to switch on the device.
4. Guide the nozzle over the surface to be cleaned. Check
during use whether the maximum fi ll level (marking) on
the collecting container has been reached. If this is the
case, it needs to be emptied.
5. To switch off the cordless vacuum cleaner, press the On/
Off switch.
2. Fill the spray bottle: Unscrew the spray head from the spray
bottle and fi ll the bottle with cleaning agent and water in
accordance with the manufacturer's specifi cations.
3. Screw the spray head back onto the bottle with the fi xing
ring.
4. Place the wiping attachment onto the spray head and
press it into the fi xing ring until both parts lock inside one
another.
5. Spray the cleaning agent evenly onto the surface which
is to be cleaned. To do this, press the spray lever of the
bottle.
6. Detach the dirt using the wiping cloth. Note: If necessary,
rinse out the wiping cloth under running water!
7. Insert the window nozzle into the suction opening of the
device.
8. Switch on the device and suck up the cleaning liquid from
the surface by dragging the device from top to bottom.
9. The further procedure is the same as that for using the
device in the conventional way (see above).