EN
Troubleshooting
If the device is not working properly, please check whether you are able to rectify the
problem yourself fi rst.
Do not attempt to repair a defective device yourself!
Problem
The device only works
slowly or does not start.
Dust escapes from the de-
vice during cleaning.
Low suction force.
The control lamp does not
light up when the device
is connected to the mains
power.
Streaks when cleaning win-
dows or smooth surfaces.
Technical Data
Article no.:
Device
Model:
Voltage supply:
Motor power:
Battery charging time:
Battery operating time:
Collecting container, max. fi ll level: 500 ml
26
Possible cause/solution
•
Is the battery fl at? Recharge it.
•
Check whether the collecting container, insert and
fi lter are inserted correctly and adjust the fi tting if
necessary.
•
Is the collecting container full? Empty it.
•
Is the fi lter heavily clogged up? Clean it.
•
Is the suction opening/nozzle blocked? Switch off
the device and remove the blockage.
•
It is also possible that some smaller items will
remain stuck to the carpet or will be too big/heavy
to be picked up by the device.
•
Is the charger connected to the plug socket and
the connecting socket on the device properly?
•
Is the plug socket defective? Try another plug
socket.
•
Check the fuse of your mains connection.
•
Clean the scraper lip.
•
Turn over a worn scraper lip: Pull the scraper lip
sideways out of its holder, moisten with water or
cleaning agent in the rounded area and slide back
into the holder the other way round.
•
Replace the scraper lip if necessary: If after turn-
ing the scraper lip over both edges are worn, a
new scraper lip is required. Replace the scraper
lip in the manner described above.
•
Check the metering of the cleaning agent.
05348
PC-P003W
7.2 V DC (Ni-MH battery pack), 1400 mAh
60 W
approx. 7-11 hours (The fi rst charge lasts for
approx. 12-15 hours.)
approx. 20 minutes