Maintenance And Safety Check - Jackle maxiMIG 250 Betriebsanleitung

18. Maintenance and safety check

The welding unit is, on principle, maintenance-free. However, make it a rule to carry out the following work:
- Clean current contact tip and gas nozzle regularly, removing welding spatter and other impurities. Add Anti-
Stick agent on nozzles after cleaning to reduce undesirable spatter adhesion.
- Check current contact tip regularly for wear or damage, replace in time.
- Clean the welding unit by air-blasting from inside according to pollution level.
Attention:
This Welding unit has to be safety checked every year by JÄCKLE Company or another special qualified
electrician according to the harmonized standard
IEC 60974 – 4
Safety, maintenance and inspection of arc welding equipment in use
Operating manual
Disconnect mains prior to any service and maintenance work!
maxiMIG 250/300
Page 24