Maintenance And Safety Check; Overtemperature; Water Cooling (Option) - Jackle MIG 505 Betriebsanleitung

35. Maintenance and safety check

The welding unit is, on principle, maintenance-free. However, make it a rule to carry out the following work:
Clean current contact tip and gas nozzle regularly, removing welding spatter and other impurities. Add Anti-Stick
agent on nozzles after cleaning to reduce undesirable spatter adhesion.
Check current contact tip regularly for wear or damage, replace in time.
Clean the welding unit by air-blasting from inside according to pollution level.
Attention:
This Welding unit has to be safety checked every year by JÄCKLE Company or another special qualified
electrician according to the harmonized standard
IEC 60974 – 4
Safety, maintenance and inspection of arc welding equipment in use

36. Overtemperature

When the machine is getting hot during welding, it switched off and it can not be welded, until the machine is
cooled.
In overtemperature conditions the following text appears in the displays:
t°C = hot = temperature to high

37. Water cooling (Option)

The torch is cooled by a built-in low-noise, pump-operated water-cooling system. The water tank shouldbe kept
almost full. In case of loss of water due to exchange of torch or hose sections, check water level in the tank.
Low-water switch
If the cooling water pressure drops, a manometric switch cuts off the mains contactor. Welding wire will still be
conveyed, but there is no current flow.
The unit will be operable again when normal working pressure has been restored in the cooling system.
- ONLY use JÄCKLE coolant JPP (Order No. 900.020.400)
- Unsuitable coolants can cause property damage and loss of warranty.
- Do not mix with water or other coolant.
- Do not weld without cooling water! Tank must always be full.
- Pump must not run dry, not even for a short time. Deaerating the pump.
- Hazardous to health – keep away from children!
MATERIAL SAFETY DATA on
- Frost-resistance up to -30°C
Operating manual
Disconnect mains prior to any service and maintenance work!
t°C
www.jaeckle-sst.de
- 03 - hot
available.
MIG 325,405,505
Page 35