Technical Data - Jackle maxiMIG 250 Betriebsanleitung

12. Technical data

Power source
Supply voltage, 50/60 Hz
Max. drawing of current
Fuse
Maximum power draw
Set-point range
Operating voltage
Open-circuit voltage
Voltage steps
Duty cycle 25 % (40° C)
Duty cycle 60 % (40° C)
Duty cycle 100 % (40° C)
System of protection
Insulation category
System of cooling
Weight
Dimensions L x W x H (mm)
Noise emission
Wire feed
Wire feed motor with
four-roller drive system
Wire feed speed
Diameter of wire
Authorized for welding under increased electrical hazard
Manufactured in accordance with EN 60 974-1 and EN 60 974-10
Generator operation:
The generator must have 30% more power as the welding unit.
Example: 13kVA (unit) + 30% = 17kVA. The generator for this unit must have 17kVA.
A generator with less power will damage the Jäckle welding unit as well as the generator himself
and is disallowed.
Operating manual
maxiMIG 250
400V, 3 Phase, +/- 10%
Imax = 15A, Ieff = 9A
16A slow
11 kVA
40 - 250A
16 – 26,5V
21 - 42V
12
250A / 26,5V
190A / 23,5V
140A / 21V
IP 22
H (180° C)
F
74 kg
880 x 365 x 750
< 70 dB(A)
42V, 50W
1,0 - 24 m/min
0.8 - 1.2 mm
maxiMIG 250/300
maxiMIG 300
400V, 3 Phase, +/- 10%
Imax = 18A, Ieff = 11A
16A slow
13 kVA
40 - 300A
16 - 29V
21 - 45V
12
300A / 29V
210A / 24,5V
170A / 22,5V
IP 22
H (180° C)
F
84 kg
880 x 365 x 750
< 70 dB(A)
Page 16