Herunterladen Inhalt Inhalt Diese Seite drucken

Technical Data; Environmental Conditions - Jackle MIG 505 Betriebsanleitung

Mit steuerbox mc 4,5,15
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

21. Technical data

Power source
Supply voltage, 50 Hz
Max. current consumption
Fuse
Max. power draw
Cos phi
Set-point range
Operating voltage
Open-circuit voltage
Voltage steps
Duty cycle 50 %
Duty cycle 60 %
Duty cycle 100 %
System of protection
Insulation class
System of cooling
Weight incl.water-cooling system
excl. water-cooling sytem
Dimensions L x W x H (mm)
Noise level
Wire feed
Wire feed motor with
Wire feed speed
Diameter of wire
Authorized for welding under increased electrical hazard
Manufactured in accordance with EN 60 974-1 and EN 60 974-10
Generator operation:
The generator must have 30% more power as the welding unit.
Example: 16kVA (unit) + 30% = 21kVA. The generator for this unit must have 21kVA.
A generator with less power will damage the Jäckle welding unit as well as the generator himself
and is disallowed.

22. Environmental conditions

The power source must be operated at a temperature between -10°C to +40°C and a relative humidity of 50% at
40°C or up to 90% at +20°C. The ambient air must be free of unusual amounts of dust, acids, corrosive gases
or substances, etc., unless they occur during welding.
To prevent damage to the machine the temperature around the machine is controlled.
If this temperature is below -10°C or above + 40°C, the following text appear on the display and the machine
can not be started:
Only when the temperature is in the prescribed range, the welding operation can be started.
Operating manual
MIG 325
400 V, 3-phase
24 A
20 A slow
16 kVA
0.8
40 - 320A
16 - 30V
19 - 50V
24 2x coarse
1x fine
320A / 30V
250A / 26,5V
IP 23
H (180° C)
F
155kg
147kg
1040 x 460 x 905
< 70 dB(A)
42 V, 140 W
1,0 - 24 m/min
0.8 - 1.6 mm
t°C - int – ‚measured temperature value'
MIG 405
400 V, 3-phase
32 A
25 A slow
22 kVA
0.8
40 - 400A
16 - 34V
19 - 55V
24 2x coarse
1x fine
400A / 34V
250A / 26,5V
IP 23
H (180° C)
161kg
153kg
1040 x 460 x 905
< 70 dB(A)
MIG 325,405,505
MIG 505
400 V, 3-phase
45 A
32 A slow
28 kVA
0.8
60 - 500A
17 - 39V
23 - 61V
24 2x coarse
1x fine
500A / 39V
440A / 36V
320A / 30V
IP 23
H (180° C)
167kg
159kg
1040 x 460 x 905
< 70 dB(A)
Page 22

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Mig 405Mig 325

Inhaltsverzeichnis