Technical Data; Environmental Conditions - Jackle Plasma 25ci IP23 Betriebsanleitung

15. Technical data

Supply voltage 1-phase
Max. power draw
Fuse
Cutting current
Max. open-circuit voltage
35 % duty cycle
60 % duty cycle
100 % duty cycle
Max. cutting thickness, quality cut
System of protection
Insulation class
Type of cooling
Dimensions L x W x H (mm)
Weight
Compressor:
Supply voltage 1-phase
Max. power draw
Max. pressure
Max. Airflow
Noise
Authorized for welding under increased electrical hazard
Manufactured in accordance with EN 60 974-1 and EN 60 974-10
Generator operation:
The generator must have 30% more power as the cutting unit.
Example: 6kVA (unit) + 30% = 8kVA. The generator for this unit must have 8kVA.
A generator with less power will damage the Jäckle cutting unit as well as the generator himself
and is disallowed.

16. Environmental conditions

The power source must be operated at a temperature between -10°C to +40°C and a relative humidity of 50% at
40°C or up to 90% at +20°C. The ambient air must be free of unusual amounts of dust, acids, corrosive gases or
substances, etc., unless they occur during cutting.
Operating manual
severance cut
230 V, 50 Hz, +/- 10%
5,6 kVA
16 A slow
7 to 25 A
460 V
25 A / 90 V
20 A / 88 V
15 A / 86 V
4 mm
6 mm
IP 23 / IP44
F (180° C)
F
425x210x390 (IP23)
590x220x410 (IP44)
17kg (IP23) / 19kg (IP44)
230 V, 50 Hz
450 W
8 bar
45l/min at 5 bar
70 db
Plasma 25ci
Page 14