Waeco MAGIC SAFE MS-620 Montage- Und Bedienungsanleitung Seite 72

Using MAGIC SAFE
The PIN code set at the plant is 1.
You can set your own PIN code to a number from 1 to 9 (see "Alter-
ing the PIN code" chapter on page 78).
9.4 Setting the service mode
You can set the alarm to service mode if, for example the vehicle is to be handed
over for repairs or inspection. In service mode, all settings for the alarm system
remain stored, even if the battery is disconnected.
To do this, proceed as follows:
➤
Deactivate the alarm system.
➤
Switch the ignition on.
➤
Press button 2 on the remote control and hold it down for 3 s.
✓
The hazard lights flash three times.
✓
The status LED glows constantly.
Switching off service mode
➤
Switch the ignition on.
➤
Press button 2 on the remote control.
✓
The alarm siren sounds three times.
✓
The service mode is switched off.
9.5 Using the panic mode
The alarm system has a panic mode. You can trigger the alarm via remote control, if
you are attacked to scare off the attacker. The ignition must be switched off for this
function.
To activate the panic mode, proceed as follows:
➤
Press button 1 on the remote control and hold it down for 3 s.
✓
The alarm siren is switched on.
✓
The hazard lights flash.
✓
The vehicle remains operational enabling you to drive away.
Switching off the panic mode
➤
Press button 1 on the remote control.
✓
The panic mode is switched off.
9.6 Using the vehicle search function
You can use MAGIC SAFE to indicate the location of your vehicle optically and
acoustically. The ignition must be switched off for this and MAGIC SAFE must be
activated.
Proceed as follows:
➤
Press button 2 on the remote control.
✓
The alarm siren sounds a signal.
✓
The hazard lights flash six times.
72
MAGIC SAFE