Waeco MAGIC SAFE MS-620 Montage- Und Bedienungsanleitung Seite 57

MAGIC SAFE
7.2 Connecting the P1 main cable tree (see Fig. 6, page 6)
➤
Plug the P1 cable tree into the corresponding connection on the control unit.
Green/brown (P1.7)
If the indicators are positively charged (the cables to the indicators conduct +12 V,
when the indicators are activated):
➤
Connect this cable to +12 V.
If the indicators are negatively charged (the cables to the indicators conduct an
earthed charge, when the indicators are activated):
➤
Connect this cable to earth.
➤
Undo the soldered connections for the two diodes (fig. 8.12, page 7) in the black/
white and black/green cables and reverse their position (polarity) and resolder
them.
Black/white and black/green (P1.8)
➤
Connect the black/white cable to the right indicator cable.
➤
Connect the black/green cable to the left indicator cable.
Red (P1.9)
➤
Connect this cable to a cable with a permanent +12 V charge (terminal +30).
Black (P1.10)
➤
Connect this cable to earth (terminal -31).
Brown (P1.11)
➤
Guide this cable through the splash-protection wall in the engine compartment.
➤
Connect this cable to the red alarm siren cable.
➤
Connect the negative pole of the alarm siren to earth.
Connecting the central locking
MAGIC SAFE has a universal connection for central locking to enable standard cen-
tral locking and engine-powered retrofitted central locking to be connected to the sys-
tem.
You can find the cable colours and their functions in the following table:
Colour
Blue/yellow
Blue/red
Red/black
Grey/yellow
Grey/red
Red/yellow
Plug
P1.1
P1.2
P1.3
P1.4
P1.5
P1.6
Function
Open normally closed
Open together
Open normally open
Closed normally closed
Close together
Close normally open
Electrical connections
57