Waeco MAGIC SAFE MS-620 Montage- Und Bedienungsanleitung Seite 60

Electrical connections
Brown/white (P2.7)
➤
Connect this cable if necessary to the optional start block relay.
The output switches to earth when the alarm system is activated and may con-
duct a maximum of 200 mA.
7.4 Connecting the status LED (P3)
➤
Insert the plug of the status LED into the P3 connection (see Fig. 6, page 6) in
the control device.
7.5 Connecting the shock sensor (P4)
➤
Insert one of the two plugs of the shock sensor cable (fig. 4.10, page 5) in the
shock sensor connection.
➤
Insert the other plug of the shock sensor cable (fig. 4.10, page 5) in the P4 con-
nection (see Fig. 6, page 6) in the control device.
7.6 Vehicle specific data
Check the polarity before connecting.
The following table is not intended to be understood as being complete. You can
obtain information on other vehicles on request from WAECO.
We reserve the right to make alterations.
60
MAGIC SAFE